Home / Products /

IMU-P Inertial Measurement Unit



IMU-P is new generation of compact size (39 x 45 x 22 mm), low weight (70 gram) and high performance Inertial Measurement Unit (IMU).

It contains 3 highly accurate Advanced MEMS gyroscopes and 3 ultra high performance accelerometers.

The IMU-P is factory fully calibrated and compensated over its operating temperature range.

IMU-P is a cost effective ITAR-free solution for systems that only had FOG's as an alternative when reaching for the performance level that IMU-P can offer.

Key features

• ITAR-free
• Same mechanical & electrical interfaces as STIM-300
• Affordable price
• 1 deg/hr gyroscopes Bias in-run stability
• 0.005 mg accelerometers Bias in-run stability
• 0.004 deg/sec√Hz gyroscopes noise (PSD)
• 0.025 mg√Hz accelerometers noise (PSD)
• Advanced, extendable, embedded Kalman Filter
• Full temperature calibration of all sensing elements
• Up to 800Hz data rate
• Environmentally sealed (IP67)

Download Datasheet

How to buy


• Antenna and Line of Sight Stabilization Systems
• Passengers trains acceleration / deceleration and jerking systems
• Motion Reference Units (MRU)
• Motion Control Sensors (MCS)
• Gimbals, EOC/IR, platforms orientation and stabilization
• GPS-Aided Inertial Navigation Systems (INS)
• Attitude and Heading Reference Systems (AHRS)
• Land vehicles navigation and motion analysis
• Buoy or Racing Boat Motion Monitoring
• UAV & AUV/ROV navigation and control